MEETING!!

INTERNATIONAL ASSOCIATION OF
ELECTRICAL INSPECTORS

GULF COAST DIVISION


DATE: February 20, 2008

TIME: LUNCH 11:30 AM – 12:30 PM
MEETING 12:30 PM - 2:00 PM

LOCATION: INTERNATIONAL
SUPER BUFFET
2200 TAMIAMI TR.
PORT CHARLOTTE

COST: $8.00


Alan Weis from SESCO LIGHTING will be present at the next meeting to give a presentation on LED technology.





2008 Meeting Schedule

January 16 February 20 March 19

April 16 May 21 June 18

July 16 August 20 September 17

October 15 November 19 December 17


2008 Officers

President: Jim Anderson

1st Vice President: Bud Keefer

Secretary: Bryan Holland

Treasurer: Mike Looney



COMMITTEES

National Electrical Code: Bill Pancake Bryan Holland
239-272-4525 941-429-7053

New Products: Mark LaSalle, 941-625-9690

Education, membership and meeting announcements: Bryan Holland
941-429-7053



Public Relations:

Budget and finance: Mike Looney, 941-474-3104 fax 941-475-1852

Entertainment: Tom Lasprogato, 941-429-7042

ECF Coordination: Bennett Rosenberger, 239-574-3449

Meeting agenda: Jim Kenna, 941-575-9302


January Meeting Minutes

Minutes of the January 16, 2007 Meeting

The January meeting of the Gulf Coast Division was called to order by President Jim Anderson. There were 28 members and guest present. The Treasurer’s report was approved as read. The minutes of the last meeting were approved as written.

Secretary Bryan Holland reported on the Florida Chapter Board of Directors Meeting held on January 12, 2008 in Orlando. Bryan then gave an update on the February NEC Code Change Seminar to be held in Punta Gorda. Due to a review of the Division By-Laws, it was determined that Associate Member Jim Johnson does not qualify as a Senior Associate Member thus cannot hold office. After a brief discussion, the membership voted Inspector Member Jonathan Peer in as 2nd Vice President due to vacancy of position. The Secretary’s report ended with a review and update of Committee Member assignments.

Bill Pancake brought up the issue of attic access lighting under the NEC Committee report. It was noted by Bill that a switch controlled lighting outlet could not be required unless the attic is identified on the plans as being used for storage. After a brief discussion, it was agreed by the group that each individual AHJ would make the determination when a light is required.

Jim Kenna notified the group that Alan Weis from Sesco Lighting will be present at the next meeting to give a presentation on LED technology.

Bennett Rosenberger notified the group that the Electrical Council of Florida will be meeting on January 29th at the Royal Palm Yacht Club. A presentation of new requirements in Section 410.73(G) and 210.12 will be covered.

In Old Business, Joe Schneeberger notified the group that he has been in contact with Peter Pluta and all is well with him and his family. They are getting settled in their new home and Pete looks forward to seeing us sometime next summer. Joe also notified the group that Ben Controneo will be present at the next meeting.

George Blanton and Ady Hardy of Square D were present at today’s meeting to give a presentation on the new combination-type AFCI breakers. A brief explanation was provided on the differences between the old branch-circuit type and new combination type. It was noted that the new Square D versions will have a WHITE test button. These new devices should be locally available at roughly 15% higher than the current AFCI prices. 2-pole versions are not yet available. Several questions were asked and answered following the presentation. A handout from NEMA was provided to all members and guests.

Under New Business and Code Discussion, Joe Schneeberger asked a question regarding the location of switches in near proximity with bathtubs and shower spaces. Section 404.4 of the NEC was discussed.

Greg Brown inquired on the required size and location of the access to equipment under a hydromassage-tub. Section 680.73 was discussed and it was noted that the manufacturer’s instructions must be followed. As a follow-up question, Bill Pancake inquired on bonding requirements at hydromassage-tubs. Sections 680.74 and 250.104(B) were discussed.

Jim Anderson mentioned that some boat lifts and residential docks may be required to meet the provisions of Article 682. The Article was briefly discussed.

Bill Pancake brought up the issue of Continuing Education at regular meetings. After a long discussion on the topic, it was agreed by the membership that CEU courses should be provided at regular meetings and/or during special events on a regular basis. The Executive and Education Committees will be meeting to discuss options and how to implement a new program.

The meeting adjourned at 2:00 PM. The next meeting will be February 20, 2008.